SATO CW408, Руководство оператора, Страница: 53 / 120

Section 3: Operation and Configuration
CW408 Operator Manual Page 3-27
3.13 DEFAULT SETTING MODE (Cont’d)
3.13.1 Table of Default Settings
The symbol “O” indicates affected items that will be reset to default values in DEFAULT MODE.
DEFAULT MODE
Menu Description
This screen shows the completion of initialization and the printer beeps three
times.
After this message is shown, set the power to off.
Items
Default Mode Default Value
Factory
Setting
Printer
Setting
I/F
Settings
Control
Code
CW408
ADJUSTMENT MODE
PITCH POSITION O — — — +0.00 mm
OFFSET POSITION (CUTTER POSITION) O — — — +0.00 mm
PRINT DARKNESS O — — — 50
BUZZER O — — — ENABLE
BRIGHTNESS — — — — 2
CANCEL PRINT JOB — — — — NO
BASIC SETTINGS
PRINT SETTINGS
ADJUSTMENT MODE — — — — PITCH
PRINT SPEED O O — — 4 IPS
PRINT DARKNESS O O — — 05
PRINT OFFSET O O — — V:+0000 H:+000
FONT SETTINGS
ZERO SLASH O O — — ENABLE
CHARACTER PITCH O O — — ENABLE
CODE PAGE O O — — CP-858
OPERATION SETTINGS
OPERATION MODE O O — — TEAR OFF (without option) /CUTTER (when
cutter is installed) /DISPENSER (when dis-
penser is installed)
MEDIA TYPE O O — — FAN-FOLD (CONTINUOUS, TEAR OFF,
CUTTER) /ROLL (DISPENSER)
BACKFEED MOTION O O — — BEFORE
SENSOR O O — — GAP
BRIGHTNESS TIMER O O — — 00
I/F SETTINGS
INTERFACE SETTING O — O — AUTO SELECT
LAN
DHCP SETTING — — — — DISABLE
RARP SETTING — — — — DISABLE
IP ADDRESS — — — — 192.168.001.001
SUBNET MASK — — — — 255.255.255.000
GATEWAY ADDRESS — — — — 0.0.0.0
PORT NUMBER 1 — — — — 1024
PORT NUMBER 2 — — — — 1025
PORT NUMBER 3 — — — — 9100
PROTOCOL O — O — STATUS4
REPLY TIMING O — O — ENQ
FACTORY SETTING
COMPLETED
PLEASE POWER OFF
Preliminary