SATO CW408, Руководство оператора, Страница: 112 / 120

Section 8: Appendix
Page 8-6 CW408 Operator Manual
8.4 BASE REFERENCE POINT ADJUSTMENT (Cont’d)
8.4.2 Adjustment of the Stop Position
The stop position for options (such as Cutter, Dispenser and Tear-off) is adjustable within the range of +3.75
mm to -3.75 mm (+0.15” to -0.15”) using the adjustment LCD setting described above.
Note:
The above cutting position indicates the stop position when media sensor is set to Gap sensor.
The position for media in tear-off or dispense mode is adjustable in the same manner.
Adjustment requirements of stop position for various options are as follows:
Tear-off : For perforated media, position of perforation should be +0 mm to +1.0 mm (+0” to +0.04”) from
the edge of printer (Non-perforated media uses media center position as a reference.)
Dispenser: The label stop position from the dispenser is 2.0 mm ± 1.0 mm (0.08” ± 0.04”).
Cutter: For perforated media, cut the media after the perforation.
(For the non-perforated media, cut the center po/- 0.5 mm (+/- 0.02”) of the media.)
Adjustment Location Adjustment Range
Adjustment mode: Offset/ Cut position +3.75 mm to -3.75 mm (+0.15” to -0.15”)
-3.75 mm (-0.15”)
Media feed direction
Base reference
point for printing
(Print head)
Adjustment for
“+” value
No
Adjustment
Adjustment for
“-” value
Cut position
+3.75 mm (+0.15”)
24.0 mm
(0.95”)
Label
Dispenser
bar
2.0 mm ±1.0 mm
(0.08” ± 0.04”)
Perforation
Media Feed
Direction
Tear-Off Stop Position Dispenser Stop Position Cutter Position
Bottom Case
Within 1.0 mm (0.04”) Within 1.0 mm (0.04”)
Perforation
Label
Preliminary