SATO ARGOX OS-200 Series, Руководство пользователя

Страница: 57 / 67

OS-214EX / OS-200
User Manual
51
5.4 Ribbon Problems
The ribbon is out

Load a new ribbon roll.
The ribbon is broken

Check the print darkness and adjust it if it is too high, and take the following
steps to fix the broken ribbon:
1. Unload the ribbon supply roll and take-up roll from the printer.
2. Pull the ribbon from the supply roll so it overlaps the broken end of the take-up
roll.
3. Tape the overlapped parts together.
4. Reload both rolls into the printer.
The ribbon is “printed out” with the media

The ribbon is not loaded correctly. See the “Load Ribbon” section to reload the
ribbon.

The printhead temperature is too high. Reload the ribbon and print a
configuration label to check the settings (see the “Self Test mode” section). If
the print darkness is very high, adjust it in printer preference, or reset your
printer (see the “Restore Your Printer” section).
The ribbon is wrinkled
1. Make sure the ribbon is loaded correctly.
2. Rotate the Take-Up Wheel to straighten the ribbon.