Satel VERSA Plus LTE, Руководство по установке

Страница: 30 / 40

28 VERSA Plus LTE SATEL
5. Press the key with the number corresponding to the new address. The address change
will be confirmed by four short beeps followed by a long one. Pressing allow to
change the address again (the keypad restart will follow and information on the current
address will be displayed again).
6. Power off the keypad.
7. Open the CLK and DTA keypad terminals.
8. Connect cables properly to the CLK and DTA keypad terminals.
9. Power on the keypad.
5.14 Identification of devices connected to the bus
Devices connected to the communication bus will not be properly supported, unless they
have been identified by the control panel. Identification of the devices is required after the
first start-up of the control panel and then each time after a new device is added or the
address was changed in a device supported by the control panel.
Disconnecting an identified device from the communication bus will trigger the tamper
alarm.
5.14.1 Starting the identification function from keypad
1. Enter the service code (by default 12345) and press the key.
2. Press in turn the keys. The service mode will start.
3. Press in turn the keys. The I
DENTIFICATION
function will start.
Three short beeps will indicate that identification has been completed and information on
the identified devices will be presented (on the display in the LCD keypad and by means
of LEDs in the LED keypad).
4. Press the key to quit the function.
If the identification is terminated by two long beeps, this means that a wrong address
is set in the device connected to the communication bus (unsuitable for this type of
device or the same in at least two devices). The displayed message (in the LCD
keypad) or the flashing LED corresponding to the device address (in the LED keypad)
will be helpful in diagnosing the problem. Press
, set the correct address in the
device, and then restart the I
DENTIFICATION
function.
5.14.2 Starting the identification function from DLOADX program
1. Click on the button in the main menu. The “VERSA – Structure” window will open.
2. Click on the “Hardware” tab.
3. Click on the “Expanders” branch.
4. Click on the “Identification” button to run the identification function.
5. After the identification is finished, a window will appear with a prompt whether to read the
data. Click “OK”.
5.15 Installing the SIM card
Slots on the mainboard make it possible to install two nano-SIM cards.
If the control panel is to transmit data over the cellular network, it is recommended that
you use SIM cards with a dedicated tariff plan for M2M (machine-to-machine)
communication.