Satel KNX-BIN24, Руководство пользователя

Страница: 19 / 52

SATEL KNX-BIN24 17
Description of parameters
Timer ON duration
– the time for which the channel will be enabled during the cycle
(0 - 30000 [seconds]).
Timer OFF duration
– the time for which the channel will be disabled during the
cycle (0 - 30000 [seconds]).
Timer cycles count
– the number of cycles after which the timer will be disabled (0 – 255). If
you select “0”, the timer will not be disabled (no long button press event will be generated
in the channel).
Timer control event pair
– you can select the pair of events to control the timer. Occurrence
of the first event from the pair in the channel selected in the “Timer trigger channel” field
will enable the timer, and the second one will disable it. You can select:
Button short pressing / Button long pressing
Rising edge / Falling edge
Timer trigger channel
– the channel whose events selected in the “Timer control event pair”
field will enable / disable the timer channel (Physical channel A…H / Virtual channel A…H
/ Logic channel A…D / Timer channel A…D).
Timer autostart on bus recovery
– response of the channel to the bus power supply
restoration (No / Yes). If you select “Yes”, the timer channel will be enabled immediately
on starting the module.
Long pressing at the end
– if you select “Yes”, a long button press event can be generated
in the channel after the last cycle – disabling the timer (No / Yes). The event will only be
generated, if the value defined in the “Timer cycles count” field is higher than zero.
4.5 Configuring function blocks
20 function blocks with unique numbers from 1 to 20 can be defined in the module. The
function block can be enabled in the “General” tab (that can be seen after opening the
“Function blocks” tab), by selecting one of the following functions: switch/value transmitter,
edge response, dimmer, shutter controller, switching sequence, counter, scene controller, for
the block with the given number (“Function block 1…20” field). For each enabled function