Satel Integra 128-WRL, Руководство по установке

Страница: 27 / 37

SATEL INTEGRA 128-WRL 25
zones outputs
It. list of devices No device No device
1 APD-100 detector
8
17 APD-100 detector 17 unused/unavailable
2 APD-100 detector 18 APD-100 detector 18 unused/unavailable
3 AMD-100 detector 19 AMD-100 detector 19 unused/unavailable
4 AMD-100 detector 20 AMD-100 detector 20 unused/unavailable
5 AMD-101 detector 21 AMD-101 detector 21 unused/unavailable
6 ^ 22 AMD-101 detector 22 unused/unavailable
7 23 unused/unavailable 23 unused/unavailable
8 ASP-105 siren 24 ASP-105 siren 24 ASP-105 siren
9 ^
8
25 ASP-105 siren 25 ASP-105 siren
10 26 unused/unavailable 26 unused/unavailable
11 27 unused/unavailable 27 unused/unavailable
12 28 unused/unavailable 28 unused/unavailable
13 29 unused/unavailable 29 unused/unavailable
14 30 unused/unavailable 30 unused/unavailable
15 31 unused/unavailable 31 unused/unavailable
16 32 unused/unavailable 32 unused/unavailable
Table 4. An example of how the wireless devices should not be registered. For devices taking
up 8 positions, the system must reserve 16 zones and 16 outputs.
zones outputs
It. list of devices No device No device
1 ASP-105 siren
8
17 ASP-105 siren 17 ASP-105 siren
2 ^ 18 ASP-105 siren 18 ASP-105 siren
3 APD-100 detector 19 APD-100 detector 19 unused/unavailable
4 APD-100 detector 20 APD-100 detector 20 unused/unavailable
5 AMD-100 detector 21 AMD-100 detector 21 unused/unavailable
6 AMD-100 detector 22 AMD-100 detector 22 unused/unavailable
7 AMD-101 detector 23 AMD-101 detector 23 unused/unavailable
8 ^ 24 AMD-101 detector 24 unused/unavailable
Table 5. An example of how to correctly register the wireless devices. For 8 devices, the
system has reserved 8 zones and 8 outputs.
Several ABAX 2 / ABAX systems can work within each other's range. Automatic
synchronization with the wireless systems already in use is always performed at the control
panel start-up, and after each operation of addition/removal of supported devices. The
number of wireless devices working within each other's range depends on the R
ESPONSE
PERIOD
(see: P
ROGRAMMING
manual) and can vary from 150 to 450. The higher the response
frequency, the lower the number of devices that can work within each other's range.
5.13.1 Adding new wireless devices
Each wireless device, including the ARF-100 tester, must be registered to the control panel.
Before adding an ABAX 2 device that was previously registered to the ABAX / ABAX 2
system, you must restart it (remove the battery / power the device off for 30 seconds).
When registering a device, you must enter its serial number. The serial number sticker is
affixed to the device (location of the sticker is indicated in the manual of the device). The
serial number of each ARF-100 tester is 0000500.
Most of the ABAX 2 wireless devices are identified in the alarm system by the names
known from the ABAX system.