SATEL INTEGRA
Plus
21
Microphone n [n = microphone number (1...4)]
Speaker n [n = speaker number (1...4)]
Only listen
AVT buttons
Sound signal.
Silent alarm
Satel commands
Wait aft.event
Wait aft.disc.
Runtime
No autorst.3t.
Tamper in part.
2.1.6 Entering data by means of the keypad
Data are saved to the control panel if you press the key (in some keypads, the
key is
also available, whose function is exactly the same). The key enables exiting the function
without saving any changes.
Described below are general rules for entering data, however they may be different as
regards some functions.
Selection from the single-choice list
The upper line of display shows the function name, and the lower one – the currently
selected item. To scroll through the item list, use the
keys (down) and the
keys (up).
The
and
keys are not used.
Selection from the multiple-choice list
The functions that allow you to make multiple choice can be identified by an additional
symbol situated at the right-hand side of the display:
– displayed item is selected / option is enabled;
– displayed item is not selected / option is disabled.
Press any numeric key to change the currently displayed symbol to another one. To scroll the
list of items, use the
(down) or
(up) key.
For some functions, pressing the
or
key will switch the keypad into the
graphic
programming mode
. The and symbols are used to present on the display the current
status of up to 32 items available in the given function (these can be e.g. zones, outputs,
timers, etc.). The
key moves the cursor to the right, and the
key to the left. If the list of
items is longer than 32, pressing the
key when the cursor is placed over the last item will
display the next list, and pressing the
key when the cursor is placed over the first item will
display the previous list. Pressing the key 0, 1 or 2 three times in the graphic mode within 3
seconds will have the following effect:
000
- the symbol will be displayed at all available items;
111
- the symbol will be displayed at all available items;
222
- reversal of the selection made: the symbol will be displayed at all items where
the symbol was displayed, and the symbol where the symbol was displayed.
On pressing the
or
key, the keypad will return to the text mode.
Entering decimal and hexadecimal values
Digits are entered by pressing the suitable keys. Characters from A to F are available under
the keys with numbers 2 and 3. Keep pressing the keys until the required character appears.