SATEL
INT-VG
11
8.2 Running the VG-Soft program for the first time
1. Connect the USB port of the module to the computer port.
2. Start the VG-Soft program.
3.
You will be asked whether to connect to the voice module. Click “Yes”.
When the program has connected to the module, the module will stop communicating
with the control panel (the panel will report lack of the module).
4.
You will be asked whether to read the module data. Click “Yes”. The program will read
data from the module.
5. If you do not want to use the default names in the
voice menu (messages in the “Names”
group), enter your own names or copy the names from the control panel (“Names:
INT-
VG / Control panel” tab).
6. If the control panel is to use voice messages for notification, enter the content of these
messages (if you hav
e already entered them in the DLOADX program, go to the “Names:
INT-
VG / Control panel” tab to copy them) or upload WAV or MP3 audio files.
7.
In the “Voice” field (“Messages” tab), select the software voice synthesizer to be used for
synthesizing the messages.
8.
Click on “Synthesize all”.
9.
If macro commands are to be available in the voice menu, prepare them in the “Macros”
tab.
10. Click on
to write data to the voice module.
8.3 Restoring the voice module default settings
1. Start the VG-Soft program.
2. Connect to the voice module.
3.
Click “Configuration”
“Factory default settings”.
9. Operating the alarm control panel by means of voice menu
You can operate the alarm system by using a touch-tone (DTMF) telephone.
Depending on the control panel type, the interactive voice menu will be accessible to:
– VERSA – the users having the “INT-VG access” right;
– INTEGRA – the users having the telephone code (except where the access is gained
automatically after acknowledgement of voice messaging
– see the user manual for
INTEGRA control panels).
The installer can make the option of operating the system by phone conditional on the
partition state (the operation being only possible when the selected partitions are
armed).
9.1 Starting operation
1. Call the telephone number of the control panel. After the call is received, you will hear
three short beeps.
If the control panel answers only after the second call, hang up after the number of
rings which has been set by the installer. Call again within three minutes. Only then
will the control panel answer the call.
