10
INT-VG
SATEL
Partitions
Disarm
– click on
to select the partitions which are to be disarmed after running the
macro command.
Arm (full)
– click on
to select the partitions which are to be fully armed after running the
macro command.
Arm (“Stay” mode)
– click on
to select the partitions which are to be armed without
interior after running the macro command. This function applies to the INTEGRA control
panels.
Arm (“Stay”&”No Entry Delays” mode)
– click on
to select the partitions which are to
be armed without interior and without entry delay after running the macro command.
This function applies to the INTEGRA control panels.
Arm (night)
– click on
to select the partitions which are to be set to the night arm mode
after running the macro command. This function applies to the VERSA control panels.
Arm (day)
– click on
to select the partitions which are to be set to the day arm mode
after running the macro command. This function applies to the VERSA control panels.
Zones
Inhibit
– click on
to select the zones which are to be inhibited after running the macro
command.
Isolate
– click on
to select the zones which are to be isolated after running the macro
command.
Unbypass
– click on
to select the zones which are to be unbypassed after running the
macro command.
8.1.5
“Names: INT-VG / Control panel” tab
In each tab, the adjacent columns present names and notification messages used in the
INT-VG module and the control panel. The data from control panel are presented, if one of
the following conditions is met:
VG-Soft program was started using the button available in the DLOADX program,
the file with control panel data has been imported to the VG-Soft program.
Double click on
to copy name / message from the control panel to the voice module.
Importing the control panel data file
1.
Click “File”
“Import”
“DLOADX data file”. A dialog window will be displayed.
2. Indicate location of the file containing control panel data (file with .XCX extension
– you
can export the file from the DLOADX program by clicking “File”
“Export/Import”
“Export file”).
3.
Click on the “Open” button. The control panel data will be imported.
8.1.6 Status bar
The following information is presented on the status bar:
firmware version of the INT-VG voice module,
identifier of the INT-VG module (assigned by the VG-Soft program),
identifier of the data file (assigned by the VG-Soft program).
