Satec C191HM, Инструкция по установке и эксплуатации

Страница: 27 / 63

Chapter 3 Using the Menus
18
Chapter 3 Using The Menus
3.
Press and release to enter the setup mode. The primary menus will
appear:
Press again to activate the window of the desired primary menu.
Press .
Select CHG to initialize or modify the instrument setup, or to clear the accumulated values
stored in the instrument. Entry to this menu can be protected by a password.
Select
StA to view extended status information which may be useful during installation and
in certain applications.
Select OPS for viewing (not editing) the instrument setup options.
After selecting either OPS or CHG, the list of setup menus is displayed in the
upper window. Figure 3-1 presents a complete menu list. Depending on the
model of your instrument, some menus may not appear.
Password
The Setup Change Menu can be secured by a user-defined password comprised
of 4 digits. The instrument is shipped with password protection disabled. To
enable password protection, go to the
Access Control Menu (see Section 4.10).
The Password Menu appears if password protection is enabled.
To enter a password:
Set the first digit using the up and down arrow keys.
Press to advance to the next digit.
Set the other password digits in the same manner.
Press to continue setup. If your password is incorrect, you will return
to the Primary Selection Menu.
PASS
0000
SELECT
ENTER
SELECT
SELECT
ENTER
SELECT
StA
ENTER
SELECT
CHG
ENTER
SELECT
OPS
ENTER
StA
CHG
OPS
- Status Information Menu (see Chapter 6)
- Setup Options Menu
- Setup Change Menu (see Chapter 4)