WARNING:
• To reduce the risk of personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read
all warnings and instructions included with and on the fixture and all
fixture labels.
• Commercial installation, service and maintenance of luminaries should
be performed by a qualified licensed electrician. For The installation:
If you are unsure about the installation or maintenance of the
luminaries, consult a qualified licensed electrician and check your
local electrical code.
• Turn off electrical power at fuse or circuit breaker before wiring fixture
to the power supply.
• Turn off the power when you perform any maintenance.
• All connections should be capped with UL approved wire connectors.
• Minimum size 18 AWG or 14 AWG for continuous runs.
• Risk of Burn. Disconnect power and allow fixture to cool
before handling.
• Verify that supply voltage is correct by comparing it with the
luminaire label information.
• Do not install in a hazardous atmosphere, except where the ambient
temperature does not exceed the rated operating temperature of
the fixture.
• Keep tightly closed when in operation.
LED LANDSCAPE FLOOD
Models: 62-1200, 62-1201, 62-1202, 62-1203,62-1204,
62-1205, 62-1206, 62-1207, 62-1208
Satco Products, Inc.
Brentwood, NY 11717
ELECTRICAL REQUIREMENTS:
• The LED driver must be supplied with 120V, 50/60 Hz
and connected to an individual, properly grounded branch circuit
protected by a 20 ampere circuit breaker. Use min. 75°C supply.
GROUNDING INSTRUCTIONS:
• The grounding and bonding of the overall system shall be
done in accordance with NEC Article 600 and local codes.
TOOLS REQUIRED:
• Crescent Wrench
• Wire Strippers
• Wire Cutters
INSTALLATION:
1. Before starting ensure that the power is disconnected.
2. Unpack fixture and ensure that there are no damaged parts.
3. Attach fixture to outdoor box cover, routing the fixture wires
into the junction box. Connect fixture cables as seen in
wiring diagram. Black to Black, White to White, and Green
to Green.
Aim fixture by loosening bolt on the arm, and repositioning
to the desired angle. Tighten the bolt.
4. Wire end of cord to power supply as seen in wiring diagram.
Wiring Diagram
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixuture. Retain for future reference.
© Copyright 2020 Satco Products, Inc. 2/20
PRODUCT SPECIFICATIONS:
Model #
Volts
Watts
Lumens
Kelvin
Lt. Gray
Dark Gray
Bronze
62-1200, 62-1201, 62-1202
120V
6W
640
3000K
62-1201
62-1202
62-1200
62-1203, 62-1204, 62-1205
9W
900
62-1203
62-1204
62-1205
62-1206, 62-1207, 62-1208
12W
1240
62-1208
62-1207
62-1206
6 1/4"
4"
62-1203
62-1204
62-1205
PAR 20 Size
5 1/2"
3 1/4"
62-1200
62-1201
62-1202
PAR 16 Size
12 13/64"
(12.204mm)
4 59/64"
(4.923mm)
62-1206
62-1207
62-1208
PAR 30 Size
