SATA SATAjet 4600 B, Руководство по эксплуатации

Страница: 45 / 130

45
EN
Operating Manual SATAjet 4600 B RP/HVLP
• Make sure that the spindle pick-up is free of material and paint resi-
dues, remove residues and clean with solvent, if necessary
2. Installation and positioning of the new spindle [a, b]
• Screw in spindle [11-3]
• Turn spindle nut [11-3] to position 6 o’clock using a wrench (size 6)
[11-4]
3. Positioning and assembly of control knob [c]
• Position of knob [11-2] has to be according to illustration (line in the
knob has to be in vertical position)
• Hand-tighten screw [11-1] (Torx T20) in the knob – hold knob in the
position while tightening
10. Troubleshooting
Malfunction Cause Corrective action
Fluttering/spitting
spray fan or air bub-
bles appearing in the
gravity flow cup
Fluid tip has not been
properly tightened
Tighten fluid tip [2-1]
with universal spanner
Air distribution ring is
damaged or clogged.
Replace air distribu-
tion ring, as it will be
damaged during disas-
sembly
Air bubbles appearing
in the gravity flow cup
Loose air cap Tighten air cap [2-2]
by
hand
Gap between air cap
and fluid tip ("air cir-
cuit") is clogged
Clean air circuit, ob-
serve chapter 8
Nozzle set is clogged
or damaged
Clean nozzle set,
chapter 8, or replace,
respectively, chapter
9.1
Not enough paint ma-
terial in the gravity flow
cup
Refill gravity flow cup
[1-6]
Defective paint needle
sealing
Replace the paint nee-
dle sealing, chapter
9.3