SATA SATAjet 1800 M, Руководство по эксплуатации, Страница: 41 / 82

41
EN
Operating Instructions SATAjet 1800 M Operating Instructions SATAjet 1800 M
or replace if necessary.
Mount the paint needle seal retainer
■ Place the seal [10-9] on the nozzle head [10-10] .
■ Insert the paint needle seal retainer [10-8] .
■ Fit the gun body [10-7] in the correct position on the nozzle head.
■ Screw both fastening screws
[10-6]
tight with the Torx screwdriver.
■ Insert the control piston [10-5] .
■ Insert the paint needle [10-4] .
■ Position both springs [10-3] , [10-2] .
■ Screw on the cap [10-1] .
■ Adjust the material flow if necessary (see chapter 10.2).
11.4. Replace spindle of the round / flat fan control (only for
control module with internal round / flat can control)
Dismantle spindle
■ Unscrew the countersunk screw [11-4] .
■ Remove the control knob
[11-3]
.
■ Unscrew the spindle [11-2] using the SATA universal spanner [3-3] .
Mount the spindle
■ Screw the spindle [11-2] in using the SATA universal spanner [3-3] .
■ Position the control knob [11-3] .
■ Coat the countersunk screw [11-4] with Loctite 242 and screw hand-
tight.
11.5. Replace control piston
Attention!
Damage from incorrect installation
The sealing surface of the control piston is very sensitive and damages
easily.
→ Do not clamp piston valve on the sealing surface.
Dismantle control piston
■ Unscrew the cap [10-1] .
■ Remove both springs [10-2] , [10-3] .
■ Remove paint needle [10-4] .
■ Remove the control piston
[10-5]
.
Mount control piston
■ Insert the control piston [10-5] in the correct position.