Sartorius EVO1Y, Руководство по эксплуатации

Страница: 5 / 51

EVO1Y | LAB1Y Operating Instructions 5
Safety
2 Safety
2.1 General Safety Instructions
− The scale meets the relevant EU Directives and applicable harmonized standards
(see “EC Type Examination Certificate” in the Appendix).
− Improper use or handling, however, can result in damage and/or injury. Any
improper use or operation of the scale will result in forfeiture of all claims under
the manufacturer's warranty.
− Personnel need to have read and understood these installation instructions,
including the safety instructions.
− If the scale is used in systems and under ambient conditions with higher safety
requirements, you must observe the requirements and provisions applicable in
your country.
− Always keep the equipment and scale freely accessible.
Make sure that the voltage rating printed on the AC adapter is identical to your local
mains voltage.
The IP protection rating of the scale is IP40 in accordance with EN 60529. The device
must be handled carefully according to the IP protection rating. The environment
must be suitably secured.
Ex Zone 2 (Category 3 Equipment)
− In accordance with Directive 94/9/EC, the EVO1Y | LAB1Y model is a category 3
device, suitable for use in Zone 2 potentially explosive areas.
EC Type Examination Certificates: FM15ATEX0008X
Identification: II 3G Ex ic nA IIB T4 Gc
If the device is used in Zone 2 potentially explosive areas outside the Federal
Republic of Germany, the relevant national electrical codes and safety regulations
must be observed. Ask your dealer or Sartorius Service Center about the guidelines
that apply in their country.
2.2 Installation Instructions
Do not operate the scale if its housing, AC adapter, or any connections are damaged.
Immediately disconnect the damaged device from the power.
Do not expose the scale, the AC adapter or the accessories supplied by Sartorius to
extreme temperatures, aggressive chemical vapors, moisture, shocks, vibrations, or
strong electromagnetic fields. Observe the conditions of operation described in the
Specifications.
The casing on all connection cables as well as the casing on the wires inside the
equipment housing is made of PVC. Chemicals that corrode this material must be
kept away from these cables.
The operator shall be solely responsible for any modifications to the equipment and
for connecting any cables or equipment not supplied by Sartorius! Information on
operational quality is available upon request from Sartorius.
Only use original Sartorius accessories!