7 8
9 10
23
The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Wall Mount Installation - Round Aluminum or Wood Clock
7) Temporarily attach the clock to the mounting
piece (see step 9), use the pencil to mark the
location of the hole at the top of the release lever,
and remove the clock again (see step 11). Remove
the mounting piece and make a hole at the location
you just marked with the 1/8 inch drill bit. When
finished, reattach the mounting piece.
10) Attach the clock to the mounting piece by
sliding the clock back onto it. You should hear a
snapping noise as the latch engages.
1
2
8)
Remove the gearbox pin
, then attach the patch
cable to the port on the right side of the movement.
If the clock is able to access the Internet, it will begin
to correct itself. Make a note of the clock’s Serial
Number, which should be on a white sticker above
the port. Add this information to your tracking chart.
9) Lay any excess wiring across the strain relief base,
then attach the strain relief to the clock with the
two #6-19x7/16 screws. The strain relief should be
tight enough to prevent the wire from sliding.