• Check that the installation location is strong enough to bear the camera before proceeding.
• Install in a location (such as underneath overhangs) that is not exposed to direct sunlight.
• Install to a wall or ceiling with no unevenness in its surface.
If installing to a curved surface, round pillar or similar, use a special bracket (separately ordered).
INSTALLATION MANUAL
Color CCD Camera
☞
Please read this manual before installing and using this camera, and always follow the instructions in it for
proper use.
English
Français
Deutsch
中文简体
VCC-XZ200P
1
Setup
1
Install the camera to the wall or ceiling.
If routing the connection cord outside the wall, install so that
the connection cord hole is facing downward, and pull the
connection cord out from the hole.
Be sure to embed the mounting screws at least 3 cm into
the wall. If the screw holes are too shallow, the camera
mount may fall down.
2
Adjust the position of the camera.
Use the hexagonal wrench (large, accessory) to loosen the
screws at the place that you want to move, and then adjust
the direction of the camera.
After making the adjustment, securely re-tighten the screws.
Mounting screw: M8
3 cm or more in
Connection cord hole
Maximum 90 degrees
(to prevent cord from twisting)
Screw tightening torque after adjustment:
2 N.m or more
Screw tightening torque after adjustment:
4.3 N.m or more
Hexagonal wrench,
Large and Small . . . . . . . . . . . . . . . each 1
One-touch connector
(attached to connection cord). . . . . . . . . 1
Fixer
(for securing drop-prevention chain) . . . 1
Desiccant . . . . . . . . . . . . . . . . . . . . . . . . 1
Sunshade . . . . . . . . . . . . . . . . . . . . . . . . 1
Sunshade mounting screws
(Self-tapping type) . . . . . . . . . . . . . . . . . 2
Sunshade mounting bracket. . . . . . . . . . 1
Sunshade mounting bracket screws. . . . 2
Foil pouch
Accessories
Printed on recycled paper
1AC6P1P3050--
L5BJ2/XE (0306KP-SY)
Printed in Japan
L5BJ2(INSTALL)(GB).fm 1 ページ ２００６年３月２０日 月曜日 午後８時２２分
