Sanyo FWBP706FA, Руководство пользователя, Страница: 43 / 74

EN 43
Manual
In the following cases, configure each setting as necessary.
- When connection test failed with auto setting.
- When instructed by your Internet service provider to make specific settings in accordance with your network
environment.
IP setting
1.
Use
[ ]
to select “Setup” in the home menu, then press
[OK]
.
2. Use [ ] to select “ ”, then press [OK] .
3. Use [ ] to select “Network”, then press [OK] .
4. Use [ ] to select “IP setting”, then press [OK] .
5.
Use
[ ]
to select “Manual”, then press
[OK]
.
6. “Network Information” setting screen will appear.
Setup
Language
Streaming Co...
Security
System
Network
Network Information
Interface
Address Type
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS Ethernet
Manual
0.
0.
0.
0.
0.
0.
0.
0.
0.
0. 0.
0.
0.
0.
0. 0.
0.
0.
0.
0.
• Use [ ] to enter a number. Every short press of [ ] changes the number by 1, while every
long press changes by 10.
• The range of input numbers is between 0 and 255.
• Use [ ] to move between input fields.
• When all items are entered, press [OK] to confirm the entries.
• Press [RETURN] to complete the configurations.
7. In order to confirm that this unit is connected to the Internet, perform “Connection test” (refer to page 42).
• If this connection uses the proxy server, perform “Proxy setting” (refer to page 44) before
“Connection Test”.
Note
D
• Enter an IP address after checking the specifications of your router.
• If an IP address is unknown, check the IP address of other devices (e.g. PC connected with a LAN cable).
Then, in the fourth cell to the right, assign a different number from those other devices.
• Enter the DNS addresses provided by your Internet service provider.
• If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected via LAN cable)
and assign the same DNS address.
continued on next page