Sanyo ECO G SPW-GU055XH, Технические данные и руководство по обслуживанию, Страница: 115 / 242

3-69
1
2
3
4
5
6
7
8
Control of W-2WAY ECO-i SYSTEM
5. Schedule Timer
STEP 3 Set up the program and press the SET button.
Select timer operation with the (timer ON/ OFF) button
and (remote controller operation enable/disable) but-
ton. Then, set the trigger time with the HH and MM buttons, and
press the SET button.
When the SET button is pressed, the time set in program
changes from blinking to lighting and, at the same time, the time
set in program
starts blinking.
NOTE
Every time the button is pressed, the timer indication
changes in the order of (ON) (OFF) no indication.
Every time the button is pressed, the remote controller
indication changes in the order of (enabled) (disabled) no
indication.
The remote control operation enable/disable setting is disabled
depending on installation conditions. In this case, only timer ON/
OFF can be set.
STEP 4 Set up programs
~
in the same way.
When the SET button is pressed, settings are automatically ar-
ranged in the order of earliest time first.
If the SET button is pressed without any new settings being
made in the program, program
starts blinking again and set-
tings can be changed.
Similarly, if the SET button is pressed after setting up program
, program starts blinking again.
STEP 5 Press the PROGRAM button.
Program settings are entered and the normal display returns.
STEP 6 Set up programmed operation for other groups and days of the week in the same way.
Programs that have already been set up can be copied into other groups and days of the week. (Refer to page
3-72.)
NOTE
A “0:00” time setting is interpreted to mean 12:00 midnight.
To cancel program settings during program setup (while “PG-1” or “PG-2” is blinking on the display),
hold down the CANCEL button for more than 2 seconds. The normal display returns.
If settings are canceled without pressing the PROGRAM button, settings are not entered.