–28–
4-4.
Paper stopping
The printing paper does not exit.
If possible, take the ink cassette out.
Remove the “COVER,BACK-SVF01/EX
(03400)” on the back side and check that the printing paper is
rolled over the COMPL,PIPE DRUM RUBBER
(4A000)”.
The end of the printing paper is sticking
out.
Only the printing paper is rolling over the
“COMPL,PIPE DRUM RUBBER
(4A000)”.
Continued to A on the next page.
Catch the end of the printing paper and
take it out slowly.
Remove the cabinet parts and remove the
compl mechanism.
To set the “CAM,MECHANISM L
(5K000)” to exit paper mode 2 , rotate the worm gear on the
“COMPL,MOTOR CAM
(6A000)”.
If unable to perform step 2, take the ink cassette out.
After rotating the “PULLEY,DRUM
(4F000)” once in the reverse direction, rotate it to the regular direction
and check that the printing paper is carried out.
Rotating in regular direction
Not rotating
Rotating in reverse direction only
Rotate the “PULLEY,DRUM
(4F000)” in
the regular direction and take the printing
paper out.
Rotate the “COMPL,PIPE DRUM RUBBER
(4A000)” with the printing paper in the reverse
direction from the back side with your hand.
Rotate the “PULLEY,DRUM
(4F000)” in
the reverse direction. When the end of
the printing paper appears at the paper
exit, catch the end of the printing paper,
and take it out slowly.
Not rotating
Rotating
Dis-assemble the compl mechanism to the
point of removing the “COMPL, HOLDER,
PINCH ”. (Refer to NOTE 2.)
Remove the parts concerned with the end
of the printing paper and take the printing
paper out slowly.
Rotate the “PULLEY,DRUM
(4F000)” in the
reverse direction until the end of the
printing paper comes to the paper exit.
Catch the end of the printing paper and
take it out slowly.
NOTE 1: The rotation direction of the Motor Pulley is as follows:
“COMPL,MOTOR CAM
(6A000)
”:
When rotated in the direction shown by arrow A in Fig. A of Fig. 3-9-1 in section 3-9, the mechanism mode shifts in the
following order: Standby
Paper exit
Paper/Ribbon advance
Paper-supply
Print.
NOTE 2: “COMPL,HOLDER,PINCH
” refers to the following parts.
- “COMPL,HOLDER,PINCH SIDE
(5A000)
”
- “COMPL,HOLDER,PINCH EXIT
(5B000)
”
- “COMPL,HOLDER,PINCH PICK
(5D000)
”
- “COMPL,HOLDER,PINCH EXIT F
(5E000)
”
Содержание DVP-P1
Страница 21: ... 21 MEMO ...
Страница 30: ...Mar 04 YU Printed in Japan SANYOElectricCo Ltd Osaka Japan ...