25
MAINTENANCE
Cleaning the unit
Clean the outside of the unit with a clean soft cloth moistened with lukewarm water. Do not use benzene, thinner or alcohol since they will mar the finish
of the surfaces.
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
No picture.
The wrong function is selected.
Select the correct function.
No disc is loaded or an unplayable disc is loaded.
Load a disc or load a playable disc. (Check the disc logo, type,
colour system and regional code.)
The TV is not set to receive signal from the unit.
Select the correct input function on the TV.
No sound.
The wrong function is selected.
Select the correct function.
Volume control is set to minimum.
Turn up the volume.
The playback picture is poor.
An unplayable disc is loaded.
Load a playable disc. (Check the disc logo, type, colour system
and regional code.)
“
” appears on the TV screen.
The selected function does not operate on the disc now.
The feature or action cannot be completed at this time because:
-
The feature is not available at the moment.
-
The DVD software restricts it.
-
The DVD software does not support the feature (e.g., angles).
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
The unit does not start play.
No disc is loaded.
Load a disc.
An unplayable disc is loaded.
Load a playable disc. (Check the disc logo, type, colour system
and regional code.)
The disc is loaded with the label side down.
Load the disc correctly.
The disc is dirty.
Clean the disc or replace it.
“Parental” is set.
Cancel the parental lock function or change the rating level. Reset
it after play.
The operation or display is not normal.
The memory must be reset.
1.
Disconnect the mains lead.
2.
Reconnect the mains lead.
3.
Resume operation.
The remote control does not work properly.
The batteries in the remote control are weak, or installed incorrectly.
Check the battery polarity (+ or –).
Replace the batteries.
The remote control is not aimed at the remote sensor window.
Aim the remote control at the remote sensor window.
SLEEP TIMER OPERATION
The sleep timer automatically switches off the power after a preset time
has elapsed. The volume will gradually be reduced (fade-out) during the
1-minute period before the unit turns off. There are 4 time periods
available: 30, 60, 90 and 120 minutes.
Press the SHIFT + 6 SLEEP buttons repeatedly to select the desired sleep
time. The selected time blinks on the display. After several seconds, the
original display returns and the brightness of the display reduces.
To check the remaining sleep time
Press the SHIFT + 6 SLEEP buttons once. After several seconds, the
original display returns.
To release the sleep timer while in operation
Press the SHIFT + 6 SLEEP buttons until “SLEEP OFF” appears. The
timer is also released if the power is switched off.
