Sanyo CE32WN5F-C, Руководство по обслуживанию

Страница: 6 / 28

-6-
C3YFV
SERVICE ADJUSTMENTS
[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the service adjustments data for each circuit, therefore, when the memory IC is
replaced, it should be programmed by using “OPTION SETTING” on previous page and the following adjustments.
ADJUSTABLE SERVICE ADJUSTMENT
REGULAR
IMAGE
To enter to the Service Mode
+ Press and hold the GREEN button on the remote control and then press the P
▼
button inside of the door. Press
the P
▼
button to highlight the mode required (Regular, Image, others and TB12**). Then press the F/OK button to
select the mode.
IMPORTANT NOTICE
Do not attempt to adjust service adjustments not listed on the above otherwise it may cause
loss of performance and product safety.
Item No. OSD Description
1 P V-C P Vertical Position Adjustment
2 P H-P P Horizontal Position Adjustment
3 P V-L P Vertical Linearity Adjustment
4 P VSC P Vertical S-Correction Adjustment
5 P V-A P Vertical Size Adjustment
6 P H-S P Horizontal Size Adjustment
7 P E-P P Pin Cushion Adjustment
8 P E-T P Trapezoid Distortion Adjustment
11 P ECT P Top Corner Correction Adjustment
12 P ECB P Bottom Corner Correction Adjustment
13 P HPA P Parallelogram Distortion Adjustment
Item No. OSD Description
1 AGC AGC Adjustment
2 -- Cut-Off Drive Adjustment
3 GRY G-Drive Adjustment (white balance)
4 GRY B-Drive Adjustment (white balance)
5 CTR Contrast Adjustment (use factory setting)(for factory use)
6 -- Screen Adjustment mode
8 OSD OSD Positioning Adjustment
Note: Some items of the service adjustments for this chassis are controlled by the CPU, IC801, and the
adjustments are carried out by using the RC handset.
The available adjustment items are as follows;
Image : This can be adjusted for picture images/shapes.
Regular : This can be adjusted for the service adjustment.
other
: This is for factory setting. DO NOT ADJUST.
TB1251 : This is for the factory setting. DO NOT ADJUST.