SANY SY95C, Руководство по эксплуатации и обслуживанию

Страница: 55 / 166

MACHINE CONTROLS
3-27 SY95C Excavator OMM
Windshield
Opening the Windshield
WARNING
• Avoid sudden movement of the machine or work
equipment.
• Always place the hydraulic lockout control lever
in the locked (closed) position before opening or
closing the windshield.
Failure to follow this warning could result in death
or serious injury.
1. Before opening the front windshield (1), park the
machine on level ground, lower the work equipment
to the ground, and stop the engine.

See “Maintenance Safety” on page 2-5.
2. Place the hydraulic lockout control lever in the locked
(closed) position. See “Hydraulic Lockout Control
Lever” on page 3-22.
0004487
Figure 3-52
NOTES:
• Make sure the windshield wiper blade (7) remains
off and in the stored position while opening the
windshield to avoid damaging it.
• The right side windshield grip (6) and latch (4) are
shown. The left side is similar.
3. While sitting in the operator seat, pull the left and
right latch levers (5) back to unlock the windshield
latches. Pull back slightly on the left and right grips to
move the upper windshield roller (3) back and into
position in the track.
0004488
Figure 3-53
4. Pull back slightly on the left lower handle to position
the lower guide roller (8) into the track. This positions
the windshield to be moved up.
5. Grasp the right upper handle (2) and the left lower
windshield handle (9) and firmly move the windshield
up and back to secure it open.
NOTE: Move the handles in an upward direction to
prevent the windshield from hanging up.
0004489
Figure 3-54
CAUTION
When open, the windshield must be secured to
the roof of the cab. If it is not secure, the
windshield may slide down unexpectedly and
result in injury or damage to the machine.
The windshield latches will lock to secure the windshield
open when the latches engage the catches (10).
NOTE: The right side windshield latch is shown. The left
side windshield latch is similar.
2
5
4
7
3
6
1
8
9
10