SANY SY95C, Руководство по эксплуатации и обслуживанию

Страница: 117 / 166

MAINTENANCE
5-19 SY95C Excavator OMM
Change the Engine Oil and Filter
1. Prepare the machine for service. See “Maintenance
Safety” on page 2-5.
Dispose of used engine oil in accordance with all
applicable environmental regulations. Failure to
do so could damage the environment.
NOTE: For engine oil capacity, see “Fluid Capacities” on
page 5-8.
0004453
Figure 5-17
2. Place a suitable container under the drain valve (1).
Remove the dust cap (2).
NOTE: The oil drain tube requires a special connector to
open the spring-loaded drain valve on the engine
oil pan. Contact a SANY dealer for more
information.
0002858
Figure 5-18
3. Thread the drain tube (3) onto the drain plug until the
valve opens. Allow the oil to drain.
4. Remove the engine oil drain tube.
5. Install the dust cap and tighten it securely.
0004531
Figure 5-19
6. Open the engine hood and place a suitable container
under the engine oil filter (4). Remove the engine oil
filter.
7. Clean the engine oil filter housing mating surface as
necessary to remove O-ring residue, and inspect the
threads.
8. Apply a thin layer of engine oil to the new oil filter
O-ring gasket.
9. Install the new oil filter by hand until the oil filter
O-ring touches the oil filter housing.
Tighten the oil filter 3/4 to 1 full turn by hand to
securely install the oil filter.
NOTE: Overtightening the filter may damage the O-ring,
resulting in an oil leak.
0003987
Figure 5-20
10. Remove the engine oil filler cap (6) and add engine
oil until the level is at the upper mark on the dipstick
(5). See “Check Engine Oil Level” on page 4-6.
11. Install the engine oil filler cap.
12. Start and run the engine at low idle for 5 minutes.
13. Stop the engine and check the engine oil level. Add
oil as necessary.
1
2
3
2
4
5
6