SY26U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 1119
4-9
T
ABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Fuel Tank Filler Cover
To remove filler cover (1), turn counterclockwise.
To replace filler cover, place the cap on the filler neck and
turn clockwise.
Check and Drain the Fuel/Water Separator
A fuel/water separator separates water and sediment from
diesel fuel. Complete the following steps to drain water and
sediment from the fuel/water separator:
1. Prepare the machine for service. See “Maintenance
2. Open the engine hood.
3. Route the drain hose (2) into a suitable container. Open
the drain valve (1) and drain the water and sediment.
4. When only clean fuel flows through the drain valve,
close and hand-tighten the valve.
5. Start the engine and check for leaks.
NOTICE!
Make sure the O-ring in the filler cover is clean.
If the O-ring is contaminated by dirt or debris,
the O-ring will be damaged, preventing the filler
cover from sealing properly.
WARNING!
•
Fuel or fuel vapors that come into contact with hot surfaces or electrical components can
cause a fire.
•
Never service the fuel system near an open flame or while smoking.
•
Clean up spilled fuel immediately.
Failure to follow these warnings could result in death or serious injury.
NOTICE!
Dispose of contaminated fuel or water in accordance with all applicable environmental
regulations. Failure to do so could damage the environment.
0003167
Fig. 4-5
1
Fig. 4-6
0003227
1
2
