Maintenance
SY26U Excavator OMM
5-54
Operation and Maintenance Manual — 1119
SANY
Replace the Bucket
1. Prepare the machine for service. See “Maintenance Safety” on page 2-8.
2. Support the bucket to prevent it from rolling over when the bucket pin is removed.
3. Remove the fasteners and bucket pins (1).
4. Remove the bucket from the arm. Clean the pins and
pin bores.
5. Align the arm with a new bucket. Make sure the bucket
is secured and will not move.
6. Install the bucket pins. Install the mounting fasteners and
pins into the bucket pins.
7. Grease the bucket pins.
8. Start the engine and run it at low idle. Operate the
bucket slowly in both directions to check for binding.
CAUTION!
•
Keep fingers and other body parts away from pinch points to prevent crushing injuries
while removing or installing the bucket. Never put your finger into the pin bore during
alignment.
•
Secure buckets after removal and before servicing.
•
Bucket pins may be ejected with extreme force when removed forcefully. Do not allow
anyone to stand in front of the pins during removal.
•
Never stand or place your feet or other body part under the bucket when removing bucket
pins.
Failure to follow these precautions could result in injury.
Fig. 5-52
0001650
1
