SY26U Excavator OMM
Maintenance
SANY
Operation and Maintenance Manual — 1119
5-7
T
ABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Near Ocean (Salt Air) Environments
Before operating the machine, inspect for any signs of corrosion. Apply grease where rust is found.
After operating the machine, thoroughly wash away the salt residue, apply grease where rust is found, and perform
maintenance carefully on the electrical components to prevent corrosion.
Dusty Environments
Clean the following components:
•
Engine air filter: Clean the dust evacuator frequently. Immediately service the air filter and housing if an
air filter restriction indicator is displayed. See Check and Replace the Air Filters (See page 5-22.).
•
Radiator: Clean the radiator core frequently to prevent blockage.
•
Fuel equipment: Drain sediment frequently.
•
Fresh-air and recirculation filters: Clean the filters frequently.
Cold Environments
In cold environments with temperatures below 32°F (0°C) or below), lubricate only with the oils and fuel shown in
“Recommended Lubricants, Fuels, and Coolant” on page 5-9. Prior to starting the engine, make sure the battery is
fully charged and the battery case and the cables have not cracked.
Other Weather Environments
NOTE:
If there is evidence of overheating of bearings or bushings, loose parts, or rust during regular
inspection, increase the frequency of lubrication.
Based on experience and suggestions by lubricating oil suppliers, the lubricating intervals listed in the
“Maintenance Schedule” on page 5-11 apply only to normal operating conditions. In harsh environments,
including those with dusty and corrosive air, abnormal external temperature, extremely heavy overload, frequent
operating times, longtime duty cycle, etc., lubricating intervals should be shortened. Always follow the
“Maintenance Schedule” on page 5-11 until enough experience is obtained to establish a new schedule.
Check the Maintenance Log
The maintenance log lists regularly scheduled maintenance that should be performed by the operator or service
personnel. All maintenance performed on the machine must be recorded in the maintenance log.
