SY265C LC/SY265C LR Excavator OMM
SANY
Operation and Maintenance Manual — 0420
5-109
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Cab
Check the Grab Handles and Steps
1. Prepare the machine for service. See “Maintenance
2. Check the mounting fasteners on grab handles (1).
3. Replace any missing or damaged mounting fasteners
and tighten any loose fasteners.
4. Remove any tools, lubricants, or debris from the steps
(2). Never allow loose items to remain on the machine.
5. Clean the grab handles and steps.
Check Doors and Locks
1. Check the cab door, all access doors, and locks to make sure they close and lock properly.
2. Repair or replace any damaged cab door, access doors, or locks.
Check the Decals
All safety decals must be visible and complete. See “Machine Decals” on page 2-3 for additional information.
Check the Sheet Metal
Check all sheet-metal covers and doors for damage, loose connections, or missing fasteners.
Repair or replace sheet metal as needed using SANY-approved parts.
Clean and Check the Upper Structure and Undercarriage
The machine consists of two major component groups:
•
The undercarriage with its various components and assemblies
•
The upper structure with its various components and assemblies
Wash the exterior of the machine, then check the entire structure of the machine for signs of damage or excessive
wear.
Notify a SANY dealer if any cracks or distortion are found.
Fig. 5-152
1
2
