SANY SY16C, Руководство по эксплуатации и обслуживанию, Страница: 143 / 208

SY16C Excavator OMM Maintenance
SANY
Operation and Maintenance Manual — 0420
5-11
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
MAINTENANCE SCHEDULE
NOTE: The lubricating intervals listed in the following tables apply only to normal operating conditions. In
harsh environments, including dusty or corrosive air, extreme temperatures, heavy loads, frequent
operating times, and long duty cycles, lubricating intervals should be shortened.
Daily Inspection and Maintenance
Do the following before operation with the engine off:
• Perform daily service as necessary.
• Inspect the machine for loose or missing components.
• Clean the operator area.
• Check all controls for smooth operation and make sure they return to the neutral position.
• Make sure all safety decals are in place and are legible.
• Make sure safety equipment is in place and in operating condition.
• Check for fluid leaks.
Check the following during operation with the engine running:
• Monitor the control panel for normal machine operating parameters.
• Make sure that the machine operates normally.
• Check for fluid leaks.
Check the following after operation with the engine off and cool:
• Check service points for wear or damage.
• Clean the operator station.
• Check for fluid leaks.
• Check for loose or missing fasteners and components.
NOTICE!
Failure to perform the following procedures when and as directed can damage the machine
and cause it to operate improperly.