SANY SY155U, Руководство по эксплуатации и обслуживанию, Страница: 82 / 192

4-14
MACHINE OPERATION
SY155U Excavator OMM
0003684
Figure 4-23
3. From the operator seat, pull both windshield latches
(2). This disengages the windshield latches from the
closed position.
0003630
Figure 4-24
NOTE: The right side of the windshield is shown. The left
side is similar.
4. Using the handles (3), lift the windshield up and to
the rear of the cab ceiling until it is latched in the
open position.
Closing the Windshield
0003555
Figure 4-25
CAUTION
Close the windshield slowly to avoid pinching
hands or fingers. Failure to follow this caution
could result in personal injury or machine
damage.
1. Before closing the windshield, park the machine on
level ground, lower the work equipment to the
ground, and stop the engine.
2. Move the hydraulic lockout control lever (1) to the
locked (closed) position.
0003685
Figure 4-26
3. Hold the left and right handles (2) and pull down on
both windshield release latches (3).
4. Move the windshield forward and down while
maintaining a firm hold on the handles.
5. When the windshield reaches the lowered position,
firmly push the left and right handles forward at the
top of the windshield to engage the latches.
NOTE: The right side windshield latch is shown. The left
side is similar.
2
3
1
2
3