SANY SY155U, Руководство по эксплуатации и обслуживанию, Страница: 45 / 192

MACHINE CONTROLS
3-15 SY155U Excavator OMM
Emergency Stop Switch
0003622
Figure 3-22
If an emergency stop and quick shutdown is required, or
the engine cannot be stopped normally, push the
emergency stop switch (1).
Turn the emergency stop switch clockwise, as indicated
on the switch face, to reset the switch from the stopped
position.
Battery Disconnect Switch
0003631
Figure 3-23
NOTICE!
• Never turn the battery disconnect switch to OFF
while the engine is running.
• After the machine is shut down, wait at least 1
minute for the engine control module (ECM) to
complete its shutdown before turning the battery
disconnect switch to OFF.
Failure to follow this notice could damage the
machine or cause improper operation.
The machine is equipped with a battery disconnect
switch (1). When the switch is moved to the OFF
position, electrical power is disconnected from all
machine systems. Turn the power off when securing the
machine for the day, or as needed when performing
service.
To disconnect the battery power from the machine:
1. Move the key switch to OFF. Wait for all systems to
shut down.
2. Open the left rear access door. See “Left Rear
Access Door” on page 4-7.
3. Turn the battery disconnect switch (1) to the OFF
position.
4. Close the left rear access door.
Monitor Console
0003637
Figure 3-24
The monitor (2) displays machine status information,
warnings, and error messages. The operator can access
various screens on the monitor, allowing machine
settings to be changed. See “Monitor” on page 3-24.
The ashtray (3) is located on the monitor console.
Climate control vents (4) on the monitor console can be
opened, closed, and rotated as needed for operator
comfort or window defrost.
1
1
2
1
3
4