Installation Instruction
Wall Mount Widespread Lavatory Set
KLASSICA COLLECTIONS
Please read the instructions completely before beginning the installation.
Klassica I Collection
Model Number: 9527KL-TM
Model Number: 9529KL-TM
Klassica II Collection
Model Number: 9527KR-TM
Model Number: 9529KR-TM
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2”
Rev 06/2016
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
1/6
Klassica Crystal Collection
Model Number: 9527KT-TM
Model Number: 9529KT-TM
NOTE:
- Where tile construction is planned for the finished walls, allow for
extra thickness dimensions when roughing in the valves.
- Test for proper function before closing walls.
- Determine where the finished wall will be. This measurement is
necessary to accurately plumb in the valve.
- Install the valve making sure that the measurement between the
center of the valve inlet and the outside of the finish wall is 2-3/4”. This
measurement is called the backset.
1
- Using 1/2” IPS, connect the corner of the valves to the spout
base at the desired spread.
- Again, allow no more than 1-1/4” diameter holes for the spout and
handles.
2
ROUGH INSTALLATION
Center of Valve Inlet
Backset
Finished Wall
