Santa Fe Clasic 4029700, Инструкция по установке и эксплуатации

Страница: 10 / 16

SANTA FE CLASSIC CONDENSATE PUMP INSTALLATION INSTRUCTIONS
STEP 1: The condensate pump kit
includes: drain hose, condensate pump, two
mounting screws and instructions.
STEP 4: Cut the condensate drain hose at a 45°
angle approximately 10 inches from the unit.
STEP 7:
Insert the drain hose into the
condensate pump reservoir as shown.
STEP 2: Pre-drilled mounting holes are located
near the bottom and on the same side of the
unit as the drain hose.
STEP 5: Example of hose cut at a 45° angle.
The angle prevents the hose from sealing tight
against the bottom of the pump reservoir.
STEP 8:
Install the provided drain hose over
the condensate pump nipple.
STEP 3: Secure the condensate pump to the
unit with the two provided screws.
STEP 6:
Remove the plug as shown.
STEP 9: Route the condensate pump drain hose
to an appropriate drain and plug the condensate
pump into a standard 115VAC outlet.
10
Santa Fe Classic Installer’s & Owner’s Manual