ENGLISH
6
6. Route the housing into the downtube
access port until it exits the non-drive
side access port at the head tube. There
should be a gentle bend in the housing
from the seat stay to the downtube.
Tip: Use a pick to help guide the cable
housing out of the head tube access port.
You can also remove the fork and push the
housing by hand.
7. Install the foam tube. Spray the inner
and outer surfaces of the foam tube with
silicon spray. Insert the foam tube into the
non-drive side access port at the head
tube so it wraps around the cable housing
in the down tube (not pictured).
8. Install a third grommet onto the cable
housing and into the access port at the
head tube.
9. Make sure the housing is long enough to
allow the handlebar to rotate 180 degrees
to each side without pulling the housing
from the rear derailleur cable stop or
the shifter.
