Page 12
IMPORTANT:
Keep pressing the UP/DOWN switch in Single-step mode until the
LIFTKAR reaches the next step and stops automatically. Then release the switch.
Pressing the switch again starts the LIFTKAR on its next movement cycle. If the
switch is released by mistake during a cycle, simply press the UP/DOWN button
again to continue the movement. The Liftkar continues operating until it reaches the
end of the cycle and stops automatically. Releasing the button and pressing it again
starts the next climbing cycle.
Flashing green:
The LIFTKAR is in Continuous mode. For users with plenty of
practice. The LIFTKAR starts climbing when the UP/DOWN switch is pressed
and doesn't stop until the UP/DOWN switch is released.
Flashing red:
The LIFTKAR is overloaded. (The LED flashes for approx. 3
seconds and then goes out
– see also Operation section [4.2.1.], page 15)
Alternating red and green:
the battery pack is running low and urgently needs
to be recharged. The stairclimber will certainly manage another flight of stairs,
but it is recommended that you move down stairs and either change the battery
pack or recharge it with the quick charger supplied. In addition, an integrated
beeper provides an acoustic signal to indicate that the battery charge is low. The
beep frequency increases the lower the battery level.
2.5.3. Speed switch
Use the speed switch to select higher or lower climbing speeds.
(Figure 5, page 10)
The lower speed or single-step mode is recommended for beginners, heavy loads
and difficult situations.
