Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 48 / 136

- 46 -
5-1 Names and Functions of Parts of the Operatin Panel
5-1-1 LCD display part of the operation panel
The LCD display is a part of the LCD monitor. In conjunction with 7-segment monitor, the operation status and the
function code settings etc. can be indicated. See 5-2-2 for display contents.
5-1-2 LCD operation part
Key Name Key mark Function Summary
F1 key Switch the LCD display interface to the previous page.
F2 key Switch the LCD display interface to the next page.
*Depending on display contents, sometimes the interface can not be switched.
*Sometimes the interface displayed automatically returns to the initial interface due to operation on the operation panel or alarm.
5-1-3 LED display part
Display Display contents
7-segment monitor Frequency, output current, speed, load factor monitoring display, alarm contents, warning contents,
operation error, function code number, function code settings and so on.
Monitor mode
display
The unit of numerical values displayed by the 7-segment monitor.
Operation mode
display
The operation status of inverter (forward running, reverse running, stop, frequency lock).
Control
authorization display
Whether the operation command sent from the operation panel is active or not.
5-1-4 LED operation part
(1) Key operation
Key Name Key Mark Function Summary
Drive key

Starts forward or reverse running operation.
Stop key

Stops operation.

Can be used for releasing alarm signal in alarm condition.
Menu / Cancel
key

In Status Display mode, changes the Status Display mode to Function Code Display
mode.

In Function Code Display mode, returns to the menu state of previous page.
Set key

In Status Display mode, changes contents displayed on the 7-segment monitor.

In Function Code Display mode, confirms the value input.
Back key

In Status Display mode, changes display contents of the 7-segment monitor.

In Function Code Display mode, returns to the menu state of previous page.
Control
authorization
toggle key

Use this button to switch the operation control rights. When switching, press and
hold the key for two seconds. (It is possible to switch the operation command
selected in F1101 and the operation command from the operation panel.)
(2) Quick knob operation
Operation Name Operation Indication Function Summary
Turning (clockwise)

The value displayed by 7-segment monitor increases.
Turning
(counter-clockwise)

The value displayed by 7-segment monitor decreases.
Pressing
(press)

Confirm the value displayed by 7-segment monitor.