SANJIANG SEC1000, Инструкция по установке и наладке

Страница: 10 / 26

SEC1000 FIRE ALARM CONTROL PANEL
Page
9
of 24
4. 24VK : It refers to a 24V power supply. It provides 24V output continuously and disconnects
the power for about 4 seconds at the time the panel is reset.
4. Indications and Controls
4.1 LED indicators
FIRE Lit red when one or more devices are reporting a fire condition
TEST
Lit yellow when the panel is under zone test state. This indicator
does NOT light for any other test which is not specified by EN 54-2
FAULT Lit yellow when one or more faults on the system are detected
POWER FAULT
Lit yellow when the panel’s mains power, battery or charger is in
fault condition
SYSTEM FAULT
Lit yellow when the panel is unable to provide mandatory
functions
POWER Lit green to show the panel’s mains power or battery is functioning
DELAY
Steadily lit yellow when delay is configured as part of one or more
cause and effect rules. Flashes when there is a delay running
DISABLE
Lit yellow when one or more loop devices, zones or outputs are
disabled
EVACUATE
Lit yellow when the EVACUATE control button is pressed to
activate all sounders of the system immediately
SOUNDER
DISABLED/FAULT
Steadily lit yellow when yellow when loop sounders are disabled
Flashes when there is loop sounder in fault condition