SANDVIK CH420:01, Руководство по установке

Страница: 84 / 110

6. Mechanical installation and connections
82 © Sandvik SRP AB – Doc. no. S 223.510 en Ver. 1 CH420:01
6.5 Hydroset and lubrication systems
6.5.1 Oil tank unit
a) Install the oil tank unit in a suitable location.
See also section 4.3.1 Placement .
b) Connect the oil lines to the tank unit, see appendix A: Installation
drawings .
– Make sure that there are no kinks in the return oil hoses/pipes.
– Avoid pipe elbows. Use large-radius pipe bends instead to reduce
resistance in the piping.
– Run the piping so that it is protected against falling stones.
– Make sure that the piping is securely supported to avoid vibration.
– Make sure that the piping is free from burrs, metal shavings and dirt
before it is connected to the crusher and tank unit.
– Use normal water piping and hoses for lubrication oil lines.
– Use high-pressure piping and hoses for Hydroset oil lines.
WARNING!
Hanging load
Keep clear of hanging loads. See
section 2. Safety precautions
.
The oil tank unit weighs approximately 310 kg (680 lb).
Make sure that the SWL (Safe Work Load) of the lifting equipment is
sufficient for the load.
NOTE! The tank unit must be placed below the level of the cone crusher.
Distance tank – crusher Inclination of return oil hose
< 3 m 5°
> 3 m 10°
NOTE! The connections are already fitted to the crusher. Hoses, pipes and pipe
fittings are not supplied by Sandvik.
Minimum pressure rating of hoses/pipes in the Hydroset system:
CH420 20 MPa / 290 psi
1
1 Lifting lugs