KSwitch D4 MM Managed Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 34
8-Port
10-Port
12-Port
Management
User Management
Interfaces
Web-based management
SNMP V1, V2c, Trap, Telnet (5 sessions)
Management Security
HTTPs, SSH, Access Management, Loop Protection
Upgrade & Restore
TFTP for Configuration Import / Export and TFTP for Firmware Upgrade
Diagnostic
Syslog, Level Info / Warning / Error
Port Mirror, Per VLAN mirroring, CPU Load Monitor, Traffic Counter
ICMP Ping
DHCP
Client Mode, Server Mode, Relay Mode, Snooping
SNTP
Supported
System Status
Device info/status; Ethernet port status
Green Ethernet
Port power savings
Power
Power Input
Dual power input, removable 6-pin DC terminal block
Input Voltage Range
12 VDC to 58 VDC
Transient Protection
> 15, 000 W peak
Reverse Power Protection
Supported
Power Consumption
8 W
8 W
10 W
Indicators
Power Status Indication
Power input status
Ethernet Port Indication
Link & speed
Relay Output
1 A, 24 V, Normal close
Table 8: Hardware Specification (14-port, 18-port and 28-port Switch)
14-Port
18-Port
28-Port
Network
Operating
Store and forward, L2 wire-speed/non-blocking switching engine
MAC Address
16K
Packet Buffer
4 Mbits
Switching Fabric/Back Plane Up to 10 Gbps
Up to 10.8 Gbps
Up to 12.8 Gbps
Ethernet Connectors (RJ45 Copper & Fiber)
RJ45 Ports
10x 100 Mbps
2x 1000 Mbsp
10x 100 Mbsp
14x 100 Mbsp
2x 1000 Mbsp
14x 100 Mbsp
24x 100 Mbsp
2x 1000 Mbsp
24x 100 Mbsp
Fiber SFP Ports
2x 1000 Mbps
4x 1000 Mbps
2x 1000 Mbsp
4x 1000 Mbps
2x 1000 Mbsp
4x 1000 Mbsp
RJ45 Copper Ports
Speed
10/100 Mbps
MDI/MDIX Auto-crossover
Support straight or cross wired cables
Auto-negotiation/Duplex
10/100 Mbps speed auto-negotiation; full & half duplex
Ethernet Port Protection
1.5KV VRMS 1 minute (Hi-pot), 2KV surge immunity on RJ45 copper port
Fiber Ports
Port Types supported
1000 base SFP Slot
Fiber port connector
SFP
Optimal fiber cable
Typical 50 or 62.5/125 μm for multi-mode (mm)
Typical 8 or 9/125 μm for single mode (sm)
