KISS 2U Short V3 - User Guide, Rev. 1.1
// 23
4.1.5.
Filter Pad and Filter Pad Holder
The filter pad and the filter pad holder (Figure 9, pos. 3) are located behind the front access panel (Figure 7, pos. 3).
The filter pad protects the product from dust and dirt and will over time become soiled by pollution. If heavily soiled,
the filter pad can cause excessive heating of the product. Kontron recommends cleaning the filter pad as often as
necessary, see Chapter 10.1: Cleaning the Filter Pad.
The filter pad can be changed during operation.
The filter pad inserts into the filter pad holder. The filter pad holder fastens onto the fan assembly’s front side by
inserting the filter pad holder’s positioning latches into the fan assembly’s position holes (Figure 12, pos. 5) and then
fastening the filter pad holder’s knurled screw (Figure 9, pos. 3)
4.1.6.
Drive Bays
The KISS 2U Short V3 can be equipped with up to three drive bays D1, D2 and D3. Drive bays D1, D2 are front accessible
(Figure 9, pos. 8 and 9) and drive bay D3 (Figure 9, pos. 10) in internally accessible.
Table 4: Drive bays
Drive Bay
Location
Description
D1
Front access
one slim drive bay for slim DVD drives
D2
one 3.5" drive bay for 2.5” drives
D3
Internal
one 3.5" drive bay for 3.5” or 2.5” drives
The drives D1, D2 and D3 can be used as separate drives or configured as a RAID array using the mainboard’s chipset
RAID.
Refer to the chipset specification for the RAID type and Intel ® Rapid Storage Technology
availability.
For additional storage, use the on-board M.2 slot with a M.2 memory module, see Chapter 5/System Extension.