KBox C-103-CFL-x - User Guide, Rev. 1.0
// 74
Danger of explosion when replacing with wrong type of battery. Replace only with the same
or equivalent type recommended by the manufacturer. The lithium battery type must be UL
recognised.
Do not dispose of lithium batteries in general trash collection. Dispose of the battery according
to the local regulations dealing with the disposal of these special materials, (e.g. to the
collecting points for dispose of batteries).
10.2.
Preventive Maintenance for SSD Drives
This section applies to all M.2 and SSD devices installed into the KBox C-103-CFL system.
Because of the
limited predetermined lifespan of the M.2/SATA SSD devices, we recommend
to check the condition of your installed SSD drives via S.M.A.R.T.
regularly.
Pay attention to the manufacturer specifications for lifespan.
For replacing of these devices refer to the sections: 4.5.11 and 6.3.7.
10.3.
Replacing the Fan Tray
The operation of the KBox C-103-CFL versions with fan tray extension is permitted only with
a functional fan tray!
Defective components may only be replaced by Kontron original spare parts:
Part number of the fan tray: 9-5000-1096 for KBox C-103-CFL-4
Part number of the fan tray: 9-5000-1095 for KBox C-103-CFL-2
Part number of the fan tray: 9-5000-1094 for KBox C-103-CFL-1
The fan tray can be replaced during operation. This should only be carried-out by qualified
personnel aware of the associated dangers.
The fan will not stop immediately when the fan tray is removed during operation. Pull out
the fan tray only a few centimeters and wait until the fan comes to stop.
To replace fan tray, proceed as follows:
1.
Ensure to have access to the bottom side of the KBox C-103-CFL-4/-2/-1. The fan tray (Figure 57, pos. 1 and
Figure 58,
pos. 2) may be replaced without removing the air filter holder (Figure 57, pos. 4).
2.
Loosen the two knurled screws (Figure 57, pos. 2) of the fan tray.
3.
Pull the fan tray (Figure 58, pos. 2) out from the fan tray slot (Figure 58, pos. 3) in order to disconnect the
connector for fan power and control (Figure 33, pos. 3) from the internal fan control socket (Figure 58, pos. 10).
4.
Pull the fan tray completely out from the fan tray slot (Figure 58, pos. 3).
5.
Replace the defective fan tray with a new one.
6.
Insert the functional fan tray (Figure 58, pos. 2) into the fan tray slot (Figure 58, pos. 3).
7.
Secure the fan tray by fastening the knurled screws (Figure 57, pos. 2). By fastening of the knurled screws the
proper insertion of the fan tray into the internal socket (Figure 58, pos. 10) is ensured.
Содержание kontron KBox C-103-CFL Series
Страница 2: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank...
Страница 28: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 28 Figure 12 Block Diagram KBox C 103 CFL x...
Страница 124: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 124...
