KBox A-203-sXAL4 – User Guide Preliminary Rev. 0.2
// 35
6.2.
DC Power Connection
The KBox A-203-sXAL4 is connected by a power plug terminal (“TE Connectivity 796859-2”) connector to a DC power
source via a DC power supply wiring (only the power plug terminal is included).
The KBox A-203-sXAL4 is delivered with a DC power plug terminal (2-pin power connector). For DC connection,
prepare the connecting wires using the supplied TE Connectivity plug terminal: 796859-2.
Figure 20: Power plug terminal
1
2-pin power plug terminal
2
Slotted pan head screws
3
Screws for securing the power plug terminal
4
Location for inserting the “+24V” wire
5
Location for inserting the “0V” wire
6.2.1.
Cabling
For the pin assignment of the Phoenix power plug terminal refer to the subsection 4.5.1 “X101 - Power Input
Connector”
1.
Cut the required length three isolated wires (1 mm2) AWG18 and strip each end 5 –7 mm.
2.
Twist the striped wire-ends and provide them with ferrules.
3.
Loosen the two slotted pan head screws (Figure 20, pos. 2) of the DC plug terminal far enough so that you can
insert the end of the prepared wires.
4.
Insert the wires into the corresponding clamp of the power plug terminal. Make sure that you have the right
polarity of the connection [refer to Figure 20, Figure 5 or subsection 10.1.1, “(X101) Power Input Connector”].
5.
Fasten the screws to secure the wires into the clamps of the plug terminal.
1
3
3
2
4
5
