S&S Merlin 1500S, Руководство пользователя

Страница: 8 / 12

Merlin 1500S
User Guide
Rev: 07 05-19
8

Fan Fault
Under normal working conditions this LED is off. If a fan fault is present for more than 10 seconds,
the LED will illuminate RED.
OFF = OK
ON = the gas supply has been shut off due to a ventilation fault.
IF A FAULT IS FOUND YOU WILL NEED TO CONTACT YOUR SERVICE/MAINTENANCE COMPANY.
YOU SHOULD NOT ATTEMPT TO CARRY OUT A REPAIR UNLESS YOU ARE QUALIFIED TO DO SO.

EM Stop
If an emergency shut off button (either remote or on the panel) is pressed, the LED will illuminate
AMBER and the gas turned off. The EM Stop button must be re-set before restarting the system.
OFF = OK
ON = EM Stop button pressed

Gas Detected
Under normal working conditions this LED is off. If the external Merlin detector connected detects
gas this will show RED and the Gas valve will turn off.
OFF = OK
ON = Gas detected.

CO
2
High
Under normal working conditions this LED is off. If the concentration of CO2 in the air is at
alarm level (relevant detector required), the LED will show RED and the Gas valve will turn off.
OFF = OK
ON = the concentration of CO2 is at alarm level.
5
Maintenance
To keep your panel in good working order, you must follow these steps:

DO carefully remove any accumulated dust from the outer enclosure once a month.

NEVER use detergents or solvents to clean your device – this may permenantly or temporarily
damage the panel

NEVER spray air fresheners, hair spray, paint or other aerosols near the device.

NEVER paint the device. Paint will seal vents and interfere with the device.