14
3700 Osuna Road NE
Suite 711
Albuquerque, NM 87109
www.sandia.aero
Figure 6 - Unit Mounting With Tab/Slot Cutaway
5.
Push the unit toward the instrument panel until it stops against the bracket.
6.
While maintaining inward pressure, rotate the bottom such that the unit is now parallel to the
panel.
7.
Once parallel to the panel, apply downward pressure to ensure the upper tabs remain fully
engaged.
8.
While holding in-ward and down-ward pressure on the unit, tighten the lower screw with the 3/32
hex drive. Torque to 5 inch-lbs. Do not over-tighten.
9.
Verify that the unit is firmly attached to the instrument panel. (The bezel of the unit will stand-
off slightly from the instrument panel, which is normal.)
Motion 1:
Motion 3:
Motion 2:
