9
3700 Osuna Road NE
Suite 711
Albuquerque, NM 87109
www.sandia.aero
Section 3
–
Installation Procedures
3.1
General
Installation consists of securely fastening the mounting bracket to the instrument panel, constructing
& connecting the power cable assembly and mounting the unit to the bracket. Power-On is then
performed, followed by unit configuration and finally unit checkout procedures.
Figure 2 – Unit Front and Rear Views
3.2
Equipment Required
3.2.1
Supplied
SI-11X (Unit) ............................................... P/N 905020-00
Kit, Install Electrical SI-11X ......................... P/N TBD
Conn, “D” 25 Pos, Rcpt, Sldr Cup ............ P/N TBD
Clamp, D Conn 45/180 Deg ...................... P/N TBD
Kit, Install Mechanical SI-11X ..................... P/N 306187-00
Bracket, Mounting Front ........................... P/N 306179
Gasket........................................................ P/N 306505
Bracket, Mounting Rear ............................ P/N 306185
Screw, Phillips, Flat Undercut SS (X4) ..... 6-32 x 3/8
Nut, Nylon Insert, Std Zinc (X4) ............... 6-32
Hex Wrench, 3/32” L-WR Short ............... P/N 306333
3.2.2
Operational Software
SI-11X Operation Software ........................... P/N
905321-00-OC-VX.Y
