Instructions for programming
Page 32 of 42
4.3.8.1 ~ Numbering selections type
During the first initialization, or after a reset as described on page 25, you can set the numbering scheme of the
selections.
Selections will be indicated as follows according to the type of numbering set:
Classic mode:
Selection / Shelf Columns
Shelf 4
41
42
43
44
Shelf 3
31
32
33
34
Shelf 2
21
22
23
24
Shelf 1
11
12
13
14
New mode:
Selection / Shelf Columns
Shelf 1
10
11
12
13
Shelf 2
20
21
22
23
Shelf 3
30
31
32
33
Shelf 4
40
41
42
43
4.3.9 ~ Technician menu
General Menu
⤷
Main machine
Password
⤷
Technician menu
To proceed, you must enter the password
4 - 2 - 3 - 1
- 4
If you insert a wrong password the display turns back to the general menu.
4.3.9.1 ~ Snack Option
4.3.9.1.1 ~ Spiral detection
General Menu
⤷
Main machine
⤷
Technician menu
⤷
Snack Options
⤷
Spiral detection
This function is used to identify the number and location of the motors installed in the vending machine.
This configuration must be done each time you add or remove one or more motors.
To scan the motors of the vending machine you have to press button
and wait a few seconds.
After scanning of the motors, a graphical configuration of the motors installed into the vending machine appears
on the display.
For each shelf there is shown a graphic of how many motors have been found using a scheme composed of
dots and zeros (where the zeros are the motors found by the machine).
Example:
0. . .0.0. . .0. . .Tray 1
Selection Mode
1: Classic (11 to 10 from bottom)
2: New (10 to 19) Snack from top
4
