S&C Vista SD, Программирование

Страница: 33 / 34

Appendix E
Ground TCC Curve (OFF, TAP, MAIN) or (OFF, U1, U2, U3, U4, U5, C1, C2, C3, C4, C5
See Notes 1 and 2
For Coordinating­Tap Curves:
Minimum Pickup (Amperes) (50, 65, 80, 100, 150, 200, 250, 300, 350, 400)
For Coordinating­Main Curves:
Minimum Pickup (Amperes) (100, 150, 200, 250, 300, 350, 400)
For Curves U1­U5 and C1­C5:
Minimum Pickup (Amperes) (50 – 400, 1 A steps)
Time­Dial Multiplier U Curves (0.5 – 15.0, 0.1 steps)
Time­Dial Multiplier C Curves (0.05 – 1.0, 0.01 steps)
For Coordinating­Tap and Coordinating­Main Curves:
Instantaneous Pickup (kA) (OFF, 0.2, 0.3, 0.4, 0.5, 0.6, 0.7, 0.8, 0.9, 1, 2, 3, 4, 5, 6)
For Curves U1­U5 and C1­C5:
Instantaneous Pickup (Amperes) (OFF, 200 – 13200, 20 A steps)
For Coordinating­Tap and U1­U5 and C1­C5 Curves:
Definite Time Delay (ms) @ 60 Hz (OFF, 32, 48, 64, 80, 96)
Definite Time Delay (ms) @ 50 Hz (OFF, 40, 60, 80, 100, 120)
For Coordinating­Main Curves:
Definite Time Delay (ms) @ 60 Hz (OFF, 64, 80, 96, 112, 128)
Definite Time Delay (ms) @ 50 Hz (OFF, 80, 100, 120, 140, 160)
Note 1: Ground settings are not displayed and are disabled if the Trip mode is set for
the
1-Pole Trip
setting or if the Phase TCC curve selected is either E­speed or K­speed.
Note 2: Ground curves can be selected to provide a different TCC curve than the phase
setting. However, when TAP or MAIN is used for the phase TCC, only MAIN and TAP TCC
curves can be selected for the ground TCC setting. When a U or C curve is selected for the
Phase TCC, only the U and C families can be selected for the ground TCC setting.
S&C Instruction Sheet 695-515 33