S&B Filters 75-5100, Руководство по установке

Страница: 6 / 16

With the ignition switched off and the parking brake set,
disconnect the negative battery cable on the battery.
Note:
Failure to disconnect the battery may cause the CEL
to illuminate upon completion of the installation and
subsequent operation. Do not skip this step!
Tool Required: 10mm Socket/Wrench
1
Remove the two nuts securing engine cover then lift up
and remove the engine cover from the vehicle.
Tool Required:
10mm Socket
2
Disconnect the MAF sensor electrical connector from the
sensor.
3
Disconnect the breather and vacuum hoses. Remove the
two mounting screws on the intake box. Loosen the hose
clamp on the throttle body. Pop out the wire harness clip.
Tool Required:
10mm Socket/Wrench, Panel Removal
Tool
4
Locate the smog pump by the stock intake tube and
remove the cover by pulling out the tabs on the side and
lifting up.
5
Disconnect the electrical harness and hose from the smog
pump.
Tool Required: Panel Removal Tool, Pliers
6
DISCONNECT
DISCONNECT BREATHER
HOSE
LOOSEN HOSE CLAMP
DISCONNECT VACUUM
HOSE
REMOVE SCREW
REMOVE SCREW AND POP
OUT HARNESS CLIP
5
INSTALLATION STEPS: