San Telequip Private Limited.,
504/505 Deron Heights, Baner Road, Baner
Pune 411045, Mah, India
Phone: +91-20-27293455,9764027070,8390069393 Connecting. Converting. Leading!
email:
_______________________________________________
Page 14 of 65,
3.5.4 VCOM Settings
Generates a virtual Serial (COM) port within the device by the network connection, it is a
TCP
connection
but the encoding is an
SAN’s exclusive private protocol. There is the choice to set your
device as either a Master or a Slave in your network.
You will need a VCOM setting, proceed to go to
Basic Settings
→
VCOM Settings
and tick on the
VCOM
’s
“Enable”
box to allow configuration on the port selected.
The options for Master are similar, the only difference being on the device
’s function.
Fig. 3. 7
Choose whether your device conforms as an RTU or ASCII, which is the VCOM Mode.
VCOM Port
Using the TCP, the device listens whether there are any clients (VCOM clients),
connecting (Serial
-
IP) to its ports.
VCOM Mode
Its definition is analogous to the one in
Note:
Windows has its own restrictive Serial-IP software installed for use.
