11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: 886-2-22694456
｜
Fax: 886-2-22694451
｜
32
www.etek.com.tw
©
U
n
ic
tr
on
T
ec
h
n
olo
gie
s C
or
p
.
A
ll
spe
cif
ic
at
io
n
s
su
bje
ct
to
c
h
an
g
e
w
ith
ou
t n
oti
ce
.
www.sanav.com
www.unictron.com
Note:
(1) Any event marks with letter “
B
” (Bauto…..) represents data which was not able to send to assigned route
immediately due to priority or mobile network service is not available. The data will be sent after the issues
are cleared.
(2) The event marks with letter
“
L
”
(LAUTO) represents power saving mode for data transmission.
"LAUTO" represents a specific number of AUTO reports. The equipment will send reports at once as a group
when it has logged a fixed number of reports in the memory.
SMS Command Introduction
SMS Command setting
10.
Any setup command must be started with a “#” sign and ended up with a “*” sign. Please note that all the
characters which include “#”, “*” and comma (,) should be HALFWIDTH form.
11.
Please be aware of the upper (capital)/lower cases when entering the SMS command.
12.
While entering any SMS command, note that NO SPACE is allowed between the characters, comma and
signs in the
SMS.
13.
The comma (,) can be abbreviated if no further setup required for the command besides Set up APN for
GPRS Service. Please refer to the examples of Set up Auto Report.
14.
The device will update setting only when the password, username and setup command are all correct.
If the command is not valid, a failure report is going to be sent to the user’s cell phone.
15.
If the device set up the authorized number, SMS commands should be sent via authorized number.
16.
If the command is valid, a success report is going to be sent to the user’s cell phone.
17.
Please make sure that the Call-Forward function of SIM card is turned off and Call-Display function of SIM
card is turned on.
18.
Please make sure that the PIN-Code of SIM card if off. If the PIN-Code is necessary, use 0000 as PIN-Code.
