![background image](http://html1.mh-extra.com/html/san-ignacio/43818/43818_instruction-manual_3811637008.webp)
• The appliance can rest on any support provided it resists temperatures over 80° C.
• The appliance must be installed far from inflam mable material and at a distance of at
least 2 cm from any wall. Any cabinet over the cooker must be at least 75 cm from the
support surface.
• The location where the cooker is installed must have sufficient air recirculation and
comply with all safety test cases in force.
2. INSTALLATION
• The appliance works on liquid gas and is planned for installation using a certified flexi-
ble rubber tube in compliance with national standards in force. Use a flexible tube no
longer than 1.5 m. Always use a low-pressure regulator to connect the cooker to the
cylinder. This regulator MUST be with normalised fixed calibration at 30 mbar for bu-
tane and 37 mbar for propane (50 mbar solely for Austria and Germany). The flexible
tube should be fastened using the tube tightening ties, certified according to standards
in force, to the two corresponding ends.
• Position the full gas cylinder to the rear of the cooker on the ground. You must buy gas
cylinders compliant with this cooker. The cylinder will need to have the air bled the first
time it is refilled, to guarantee the cooker will work properly.
• Each cylinder must be checked to guarantee it is safe, particularly when it is refilled at
an authorised refil ling station. Always use a certified pressure regulator connected to
the cylinder.
• Connect the tube to the regulator rubber support and that of the appliance and fasten
it with the tube fa stening ties.
• Check that the cooker taps are CLOSED before using.
• The flexible tube should be replaced on the expiry date on it.
• The flexible tube can be dismantled to avoid sub jecting it to traction or torsion force
and it does not have narrow curves or choke points.
• Periodically check the wear status of the flexible tube and in case of leaks, do not repair,
but replace it.
• When installation is complete, check the joints are perfectly sealed, spreading a soapy
solution over them for this purpose and checking no bubbles form. NEVER USE FLAMES
TO CHECK THE JOINTS ARE SEA LED.
ATTENTION: Assembly and periodic controls of the flexible tube should be carried out by